高頻開關電源系統包括開關整流器、閥控式鉛酸蓄電池、 DC饋線柜等。雖然器件不多，但性能獨特，是保證、電網穩定供電和、持續運行的重要器件。電除塵器高頻電源廠家講述對于恒高頻電源開關電源系統，這些設備的維修保養，既關系到系統的可靠性和壽命，還直接關系到電網的正常運行。   

智能型高頻開關電源系統設備，具有高度的智能化和蓄電池免維護的特點，雖然給我們帶來了很多方便，但是在使用時要注意以下幾點，才能保證使用的安全性。   

高頻開關電源系統對環境溫度要求不高，可在-5~+40℃下正常工作，但要求室內干凈，灰塵少。另外，灰塵和濕氣將導致主機運轉不正常。而電池的溫度則要求更高，標準使用溫度為25℃，建議在15~+30℃范圍內。如果溫度過低，電池的容量每降低1℃，其容量就會下降1％；蓄電池放電容量隨著溫度的升高而增大，但壽命卻下降，長時間使用時，溫度每升高10℃，電池壽命就會減半。   

高頻開關電源系統的參數必須控制在規定的指標之內，使用時不得隨意更改。   

在使用中，直流電源系統要避免任意增加大功率的附加設備（負荷），也不能在滿負荷狀態下長時間運行。由于，工作性質決定了直流操作電源系統幾乎處于不間斷狀態，如果增較大功率負荷或基本滿負荷工作，就會導致整流模塊失靈，嚴重時變換器就會損壞。   

如果電池輸出電流過大，有觸電危險，應將其卸下，改用導電連接條(線)。輸出電線時特別注意安全，使用的工具應采取絕緣措施，確保人身和設備安全。   

高頻開關電源不管是浮充還是放電檢修試驗狀態，都要確保電壓、電流符合規定要求。過高的電壓或電流會引起電池熱失控或失水，電壓或電流太小會引起電池虧電，影響電池的壽命，特別是對電池的影響。   

由于電池的循環壽命與放電深度有關，因此在任何情況下都要防止電池短路或深度放電。充氣深度越大循環壽命越短。進行容量試驗或放電大修時，通常可達到容量的30％~50％。   

電池組應避免大電流充放電，否則會造成電池板膨脹變形，使電池組活性物質脫落，增加電池組內阻，升高溫度，嚴重時會降低電池組容量，提前終止使用壽命。閥控密封電池是貧電池，電解液比重無法測量。因此，目前判斷其優劣較為可靠的方法是放電法，也可以通過電導率儀測量電池內阻來判斷閥控密封電池的優劣，但其準度不高。

相關文章

相關產品